Page obsolete

This page is obsolete. Please, refer to Install Moonshot Libraries on a Debian/Ubuntu/Raspbian Client instead.

On this page you will find instructions on how to install the Moonshot Libraries a Debian 8 (Jessie) device to enable its use as a Moonshot Client.

Contents

Assumptions & Prerequisites

This guide assumes you have root access to the Linux device. This is required as new software needs to be installed system-wide.

1. System Preparation

First, there are a few Debian configuration options that need to be set in advance.

1.1. Add the Moonshot Repository

Add the Moonshot Debian Jessie repository to your system. To do this, run the following command (as root, or using sudo):
```
$ echo "deb http://repository.project-moonshot.org/debian-moonshot jessie main" > /etc/apt/sources.list.d/moonshot.list
```

Install the Moonshot GPG key:

$ wget -O - http://repository.project-moonshot.org/key.gpg | apt-key add -

Update the apt cache with the new repository information:
```
$ apt-get update
```

2. Install the Moonshot Client libraries

We’re now ready to install the Moonshot software and its required dependencies. Install the software by running the following command:

$ apt-get install moonshot-gss-eap moonshot-ui

3. Next steps

At this point, you now have all of the required Moonshot software on your device, including the Moonshot Identity Selector. Depending on what client application you are using and wish to enable Moonshot authentication for, you job may now be done, or you may need to go and install a Moonshot compatible version of the client software or configure your existing client. Check the section on client compatibility if you are unsure.